Planmeca ProMax 3D S User Manual page 30

CONTROL PANEL
Target
8.6.2 3D Large View 2 horizontal
120mm
(Volume Diameter
field not shown on
Planmeca ProMax 3D s)
26 Planmeca ProMax 3D s / 3D
Large View
2 horizontal
NOTE FOR PLANMECA PROMAX 3D:
Select the target area by touching the Target field.
Touching the Target field repeatedly will cycle you
through the preprogrammed target areas. The location of
the red circle on the jaw icon will change accordingly.
The target area can also be selected by simply touching
the jaw icon on the corresponding location.
Refer to section 7.1 "Planmeca ProMax 3D s" on page 15
to view the preprogrammed target areas in each program.
Confirm your selections and return to the main display by
touching OK.
If you have selected the 3D program Large View 2
horizontal, the Select primary target area display will
appear.
On the Select primary target area display, specify the
target area for the primary volume as described in section
8.6.1 "3D Standard and 3D Horizontal Pair" on page 24.
The red circle (primary volume) will move to the selected
target area.
In horizontal stitching the diameter of the primary
volume is always Full.
Stitch volume 1 =
green circle
Primary volume =
Red circle
User's Manual (3D)