Config Diffserv Class Match Srcip; Config Diffserv Class Match Srcl4Port Keyword; Config Diffserv Class Match Srcl4Port Number - NETGEAR ProSafe GSM7312 User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software

config diffserv class match srcip

This command adds to the specified class definition a match condition based on the source IP
address of a packet. The
parameter specifies an IP address. The
that although it resembles a standard subnet mask, this bit mask need not be contiguous. The
optional parameter has the effect of negating this match condition for the class (i.e.,
[exclude]
match all source IP addresses except for what is specified here).
Default
Format

config diffserv class match srcl4port keyword

This command adds to the specified class definition a match condition based on the source layer 4
port of a packet using a single keyword notation. The
DiffServ class. The value for
below). The optional
class (i.e., match all source layer 4 port numbers except for the one specified here).
The currently supported
snmp, telnet, tftp, www
as both the start and end of a port range.
Note: The srcl4port keyword, number, and range commands are alternative ways to specify a
source layer 4 port range as a match criterion.
Default
Format

config diffserv class match srcl4port number

This command adds to the specified class definition a match condition based on the source layer 4
port of a packet. The
number is required. The port number is an integer from 0 to 65535. The optional
parameter has the effect of negating this match condition for the class (i.e., match all source layer 4
ports except for the one specified here).
9-12
is the name of an existing DiffServ class. The
<classname>
<ipmask>
none
config diffserv class match srcip <classname> <ipaddr>
<ipmask> [exclude]
is one of the supported port name keywords (listed
<portkey>
parameter has the effect of negating this match condition for the
[exclude]
values are:
<portkey>
. Each of these translates into its equivalent port number, which is used
none
config diffserv class match srcl4port keyword
<classname> <portkey> [exclude]
is the name of an existing DiffServ class. One layer 4 port
<classname>
202-10009-01
parameter specifies an IP address bit mask; note
is the name of an existing
<classname>
domain, echo, ftp, ftpdata, http, smtp,
<ipaddr>
[exclude]
Differentiated Services