Protocols And Standards; Hardware Compatibility With Dlsw; Configuring Dlsw In An Ethernet Environment - HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Manual

Protocols and standards

•
RFC 1795, Data Link Switching: Switch-to-Switch Protocol AIW DLSw RIG: DLSw Closed
Pages, DLSw Standard Version 1.0
•
RFC 2166, APPN Implementer's Workshop Closed Pages Document DLSw V2.0
Enhancements

Hardware compatibility with DLSw

DLSw is not available on the following routers:
•
MSR1000.
•
MSR30-11E.
•
MSR30-11F.

Configuring DLSw in an Ethernet environment

Step
Enter system view.
1.
Enable bridging.
2.
Enable a bridge set.
3.
Enable DLSw.
4.
Create a local DLSw peer.
5.
Map a bridge set to DLSw.
6.
Add an Ethernet interface to
7.
the bridge set.
Set DLSw timers.
8.
Configure LLC2 parameters.
9.
10. Configure the multicast
function of DLSw v2.0.
11. Configure the maximal
attempts of sending an
explorer frame in DLSw v2.0.
12. Apply an ACL in DLSw so
DLSw handles only Ethernet
frames that match the ACL.
13. Configure DLSw Ethernet
redundancy.
14. Configure local reachable
MAC or SAP addresses.
Command
system-view
bridge enable
bridge bridge-set enable
dlsw enable
"Creating DLSw peers."
See
"Mapping a bridge set to
See
DLSw."
"Adding an Ethernet interface
See
to a bridge set."
"Setting DLSw timers."
See
"Configuring LLC2
See
parameters."
"Configuring the multicast
See
function of DLSw v2.0."
"Configuring the maximum
See
number of DLSw v2.0 explorer
retries."
"Applying an ACL in
See
"Configuring DLSw Ethernet
See
redundancy."
"Configuring local reachable
See
MAC or SAP addresses."
223
Remarks
N/A
N/A
N/A
Optional.
Enabled by default.
N/A
N/A
N/A
Optional.
Optional.
Optional.
Optional.
DLSw."
Optional.
Optional.
Optional.