HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Manual page 32

•
After you configure the undo ppp mp fragment enable command on an interface, the settings
configured with the ppp mp lfi and ppp mp min-fragment commands become invalid on the
interface.
•
When MP binding is based on descriptor only, users cannot be differentiated. To bind users to
different MP bundles, set the binding mode to both.
•
When MP binding is based on authentication username only, peer devices cannot be
differentiated. If an MP bundle involves multiple devices, set the binding mode to both.
•
For a VT interface, if a static route is used, specify the next hop rather than the outgoing
interface. If the outgoing interface must be specified, make sure that the physical interfaces
bound to the VT are active to ensure normal transport of packets.
•
For more information about configuring MP parameters in Dialer interface view, see
"Configuring DCC."
To configure other optional parameters:
Step
Enter system view.
1.
Create an MP VT interface
2.
or enter dialer interface view.
Set the binding mode.
3.
Set the maximum number of
4.
links allowed in an MP
bundle.
Set the minimum number of
5.
links required in an MP
bundle.
Configure the MP sort buffer
6.
size factor.
Enable MP fragmentation.
7.
Set the minimum size of MP
8.
fragments.
Command
system-view
interface { dialer |
virtual-template } number
ppp mp binding-mode
{ authentication | both |
descriptor }
ppp mp max-bind max-bind-num
ppp mp min-bind min-bind-num
ppp mp sort-buffer-size size
ppp mp fragment enable
ppp mp min-fragment size
21
Remarks
N/A
The interface virtual-template
command also leads you to VT
interface view.
Optional.
By default, MP binding is based
on both the PPP authentication
username and the descriptor.
Optional.
16 by default.
This command is available in VT
interface view and dialer interface
view.
Inappropriate use of this
command can cause PPP
performance degradation. Make
sure you understand the impact of
this command on your network
before you use it.
Optional.
This command is available only in
dialer interface view.
By default, the minimum number
of links in an MP bundle is 0, that
is, MP dialup depends on traffic
detection.
Optional.
1 by default.
The MP sort buffer size = The
number of channels in the current
MP bundle × size.
Optional.
Enabled by default.
Optional.
128 bytes by default.