Configuring The Negotiation Parameters Of Isdn Layer 3 Protocol - HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Manual

Step
16. Configure ISDN to carry the
Calling-Name field in
outgoing packets.
17. Configure ISDN to carry the
Connected-Name field in
outgoing packets.
18. Configure ISDN to carry the
Channel-ID field for only
once in the response.
19. Configure the service type in
the ISDN bearer
compatibility signaling.
20. Configure the progress
indicator value in the ISDN
signaling.
Configuring the negotiation parameters of ISDN
layer 3 protocol
Step
Enter system view.
1.
Enter interface view.
2.
Set the length of the call
3.
reference adopted when the
ISDN interface initiates a
call.
Configure how the ISDN
4.
protocol handles CONNECT
ACK messages.
Command
"Configuring ISDN to carry
See
the Calling-Name field in outgoing
packets."
"Configuring ISDN to carry
See
the Connected-Name field in
outgoing packets."
"Configuring ISDN to carry
See
the Channel-ID field for only once
in the responses."
"Configuring the service type
See
in the ISDN bearer compatibility
signaling."
"Setting the progress indicator
See
value in ISDN signaling
messages."
Command
system-view
interface interface-type
interface-number
isdn crlength
call-reference-length
isdn ignore connect-ack
[ incoming | outgoing ]
62
Remarks
Optional.
Optional.
Optional.
Optional.
Optional.
Remarks
N/A
N/A
Optional.
The call reference length is 2
bytes for CE1 PRI and CT1 PRI
interfaces and 1 byte for BRI
interfaces by default.
Optional.
By default, if the router is
communicating with an ISDN
switch:
•
The ISDN protocol must wait
for the CONNECT ACK in
response to the CONNECT
message before it can switch
to the ACTIVE state to start
the data and voice service
communications.
•
After the ISDN protocol
receives a CONNECT
message, it needs to
respond to the peer with a
CONNECT ACK message.