Configuring Dte Side Frame Relay; Configuring Basic Dte Side Frame Relay; Configuring Frame Relay Address Mappings - HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Manual

Task
Enabling the trap function
You can configure an NNI interface in the same way a DCE interface is configured. For the
configuration procedure, see
If one endpoint of a link is an NNI interface, the peer endpoint must also be an NNI interface.

Configuring DTE side frame relay

Configuring basic DTE side frame relay

Step
Enter system view.
1.
Enter the view of the
2.
interface connecting to the
Frame Relay network.
Enable frame relay on the
3.
interface.
Set the frame relay interface
4.
type to DTE.
Configure frame relay LMI
5.
protocol type.
Configure DTE side N391.
6.
Configure DTE side N392.
7.
Configure DTE side N393.
8.
Configure DTE side T391.
9.

Configuring frame relay address mappings

Configure frame relay address mappings in one of the following ways:
•
Manually create static mappings between remote IP addresses and local DLCIs. Use this
method when the network topology is relatively stable and no new users are expected in a
certain period of time. Because static mappings do not change, the network connections are
stable, and attacks from unknown users are avoided.
Configuring Annex G
Marking the DE bit
Configuring frame relay fragmentation
"Configuring DCE side frame
Command
system-view
interface interface-type
interface-number
link-protocol fr [ ietf |
nonstandard ]
fr interface-type dte
fr lmi type { ansi | nonstandard |
q933a | bi-direction }
fr lmi n391dte n391-value
fr lmi n392dte n392-value
fr lmi n393dte n393-value
timer hold seconds
relay."
89
Remarks
Optional
Optional
Optional
Optional
Remarks
N/A
N/A
The default link layer protocol of a
WAN interface is PPP.
Optional.
The default setting is DTE.
Optional.
The default setting is q933a.
Support for the bi-direction
keyword varies with device
models.
Optional.
The default setting is 6.
Optional.
The default setting is 3.
Optional.
The default setting is 4.
Optional.
The default setting is 10 seconds.