Configuring Local Reachable Mac Or Sap Addresses; Configuring Remote Reachability Information - HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Manual

Step
Enable SDLC simultaneous
9.
mode.
10. Configure the SDLC polling
interval.
11. Configure the amount of time
the primary SDLC station
waits for an acknowledgment
from the receiving secondary
station.
12. Configure the amount of time
a secondary SDLC station
waits for an acknowledgment
from the receiving primary
station.
Configuring local reachable MAC or SAP
addresses
When network topology is stable, to reduce the exploring time before the routers send information
frames, manually configure the local reachable MAC addresses or SAP addresses.
To configure the local reachable MAC addresses or SAP addresses:
Step
Enter system view.
1.
Specify a local reachable
2.
MAC address or SAP
address.

Configuring remote reachability information

To reduce the exploring time before the routers send information frames when network topology is
stable, manually configure the reachability information of the remote end for the router.
To configure the remote reachability information:
Step
Enter system view.
1.
Configure the reachability
2.
information of the remote
end.
Command
sdlc simultaneous
sdlc timer poll mseconds
sdlc timer ack mseconds
sdlc timer lifetime mseconds
Command
system-view
dlsw reachable { mac-address
mac-address [ mask mask ] |
mac-exclusivity | saps saps-list }
Command
system-view
dlsw reachable-cache
mac-address remote ip-address
234
Remarks
Optional.
Alternate mode by default.
Generally, this configuration is not
required.
Optional.
1000 ms by default.
Optional.
3000 ms by default.
Optional.
500 ms by default.
Remarks
N/A
No local reachable MAC or SAP
addresses are configured by
default.
Remarks
N/A
No remote reachability
information is configured by
default.