Mp Configuration Example - HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Manual

Verify the configuration:
3.
# After the configuration is complete, display summary information about Serial 2/0 on Router
B.
[RouterB-Serial2/0] display interface serial 2/0 brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
S2/0
The output shows Serial 2/0 obtains IP address 200.1.1.10 through PPP negotiation.
# Ping Serial 2/0 of Router A from Router B.
[RouterB-Serial2/0] ping 200.1.1.1
PING 200.1.1.1: 56
Reply from 200.1.1.1: bytes=56 Sequence=1 ttl=255 time=1 ms
Reply from 200.1.1.1: bytes=56 Sequence=2 ttl=255 time=4 ms
Reply from 200.1.1.1: bytes=56 Sequence=3 ttl=255 time=4 ms
Reply from 200.1.1.1: bytes=56 Sequence=4 ttl=255 time=10 ms
Reply from 200.1.1.1: bytes=56 Sequence=5 ttl=255 time=4 ms
--- 200.1.1.1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 1/4/10 ms
The output shows Serial 2/0 of Router A can be pinged.

MP configuration example

Network requirements
As shown in
•
On an E1 interface of Router A, four channels are created with the interface names Serial 2/0:1,
Serial 2/0:2, Serial 2/0:3, and Serial 2/0:4.
•
On Router B, two channels are created with the interface names Serial 2/0:1 and Serial 2/0:2. It
is the same case with Router C.
Do the following:
•
Bind two channels on Router A with the two channels on Router B and another two channels
with the two channels on Router C.
•
Adopt binding authentication.
Link Protocol Main IP
UP
data bytes, press CTRL_C to break
Figure 8:
UP 200.1.1.10
34
Description