Configuring Isdn Caller Identification Callback With Rs-Dcc - HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Manual

Step
Configure one or multiple
4.
destination addresses and
dial strings.
Configure a dial number for
5.
placing calls to a single
remote end.

Configuring ISDN caller identification callback with RS-DCC

You can configure the router as the client or server of ISDN caller identification callback with
RS-DCC.
Configuration guidelines
•
The number configured in the dialer number command on the dialer interface is not required to
be the same as the incoming number.
•
To leave enough time for a server to call back, set the interval for DCC to make the next call
attempt on the client at least 10 seconds longer than that of the server. Hewlett Packard
Enterprise recommends that you set the interval on the server to 5 seconds (the default) and
that on the client to 15 seconds.
Configuring the client of ISDN caller identification callback
Step
Enter system view.
1.
Enter dialer interface view.
2.
Configure a dial string for
3.
calling a remote end.
Set the interval for DCC to
4.
make the next call attempt.
Configuring the server of ISDN caller identification callback
Step
Enter system view.
1.
Enter dialer interface view.
2.
Configure the local end to place ISDN return
3.
calls for the specified ISDN calling number.
Configure a dial string for calling a remote end.
4.
Command
dialer route protocol next-hop-address
[ mask network-mask-length ] [ user
hostname | broadcast ] * dial-number
[ autodial | interface interface-type
interface-number ] *
dialer number dial-number
Command
system-view
interface dialer interface-number
dialer number dial-number
dialer timer enable seconds
Command
system-view
interface dialer interface-number
dialer call-in remote-number [ callback ]
dialer number dial-number
144
Remarks
N/A
Optional.
Use this command instead
of the dialer route
command if only one
remote destination
address is involved.
Remarks
N/A
N/A
N/A
Optional.
Hewlett Packard Enterprise
recommends that you use 15
seconds.