Configuring A Pppoe Client; Configuring A Dialer Interface - HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Manual

Step
Return to system view.
9.
10. Set the maximum number of
PPPoE sessions allowed for
a peer MAC address.
11. Set the maximum number of
PPPoE sessions allowed for
a local MAC address.
12. Set the maximum number of
PPPoE sessions allowed for
a device.
13. Set the upper threshold for
the PPPoE abnormal offline
event count.
14. Set the upper threshold for
the PPPoE abnormal offline
event percentage.
15. Set the lower threshold for
the PPPoE normal offline
event percentage.
16. Configure authentication
and accounting on PPP
users.
17. Disable PPP log displaying.
When you configure a static route on a VT interface, specify the next hop instead of the outgoing
interface. If the outgoing interface is required, make sure the physical interface bound to the VT
interface is effective to ensure normal transport of packets.

Configuring a PPPoE client

PPPoE client configuration includes dialer interface configuration and PPPoE session configuration.

Configuring a dialer interface

Before establishing a PPPoE session, you must first create a dialer interface and configure a dialer
bundle on the interface. Each PPPoE session uniquely corresponds to a dialer bundle and each
dialer bundle uniquely corresponds to a dialer interface. A PPPoE session uniquely corresponds to a
dialer interface.
Command
quit
pppoe-server max-sessions
remote-mac number
pppoe-server max-sessions
local-mac number
pppoe-server max-sessions
total number
pppoe-server
abnormal-offline-count
threshold number
pppoe-server
abnormal-offline-percent
threshold number
pppoe-server
normal-offline-percent
threshold number
See Security Configuration Guide.
pppoe-server log-information
off
48
Remarks
N/A
Optional.
100 by default.
Optional.
100 by default.
Optional.
4096 by default.
Optional.
65535 by default.
If the PPPoE abnormal offline
event count in the last 5 minutes
exceeds this threshold, the
system outputs a trap message.
Optional.
100 by default.
If the PPPoE abnormal offline
event percentage in the last 5
minutes exceeds this threshold,
the system outputs a trap
message.
Optional.
0 by default.
If the PPPoE normal offline event
percentage in the last 5 minutes
is lower than this threshold, the
system outputs a trap message.
Optional.
Optional.
Enabled by default.