Return To The Factory Settings "Reset Param; Carrying Out An Auto-Detect - REMEHA Quinta Pro 30 Installation And Service Manual

Quinta Pro 45 - 65 - 90 - 115
3x
...x
3x
...x
080310 - 123157-AA
5.7.5.
1. Press the two keys f simultaneously and then key [+] until the
2. Select the installers menu using the key S. c0de appears
3. Use keys [-] or [+] to input the installer code 0012.
4. Confirm using key S. p[1 is displayed with 1 flashing.
5. Press the [+] key several times. p[df is displayed with df
6. Press the S key. df[x is displayed with x flashing. This is
7. Enter the value of X shown on the type plate using the [-] or [+]
8. Confirm the value with the S key, df[y is displayed with y
9. Enter the value of Y shown on the type plate using the [-] or [+]
10.Confirm the value with the S key. The factory settings are reset.
11.The display returns to the current operating mode.
T000820-H
5.7.6.
After removing the SCU-S02 PCB, an auto-detect must be carried
out. To do this, proceed as follows:
1. Press the two keys f simultaneously and then key [+] until the
2. Select the installers menu using the key S. c0de appears
3. Use keys [-] or [+] to input the installer code 0012.
4. Confirm using key S. p[1 is displayed with 1 flashing.
5. Press the [+] key several times. p[Zd is displayed with Zd
6. Confirm using key S. Auto-detect is carried out.
7. The display returns to the current operating mode.
T000445-B
Return to the factory settings "Reset
Param"
symbol ? flashes on the menu bar.
on the display.
flashing.
the current value of X for dF. Check this against the value of X on
the type plate.
key.
flashing. This is the current value of Y for dU. Check this against
the value of Y on the type plate.
key.

Carrying out an auto-detect

symbol ? flashes on the menu bar.
on the display.
flashing.
5. Start-up
69