Return To The Factory Settings; Carrying Out An Auto-Detect - REMEHA Quinta Pro 30 Installation, User And Service Manual

Fig.54 Resetting factory settings
3x
...x
Fig.55

Carrying out an auto-detect

3x
...x
123157 - v.12 - 07022018
9.2.4

Return to the factory settings

1. Press the two
until the symbol flashes in the menu bar.
2. Select the installer menu using the
3. Use the
4. To confirm, press the
:
5. Press the
with a flashing
6. To confirm, press the
dF. Check this against the value of X on the type plate.
7. Enter the value of X shown on the type plate using the
keys.
8. To confirm, press the
for dU. Check this against the value of Y on the type plate.
9. Enter the value of Y shown on the type plate using the
keys.
10. To confirm, press the
The factory settings are reset.
11. The display returns to the current operating mode.
AD-0000078-01
9.2.5 Carrying out an auto-detect
After removing a PCB, an auto-detect must be carried out. Proceed as fol­
lows:
1. Press the two
until the symbol flashes in the menu bar.
2. Select the installer menu using the
3. Use the
4. To confirm, press the
:
5. Press the
with a flashing
6. To confirm, press the
Auto-detect is carried out.
7. The display returns to the current operating mode.
AD-0000079-01
keys at the same time and then press the
appears on the display.
or keys to set the installer code
key.
appears with a flashing
key several times until
.
key.
appears with a flashing
key.
: appears with a flashing
key.
keys at the same time and then press the
appears on the display.
or keys to set the installer code
key.
appears with a flashing
key several times until
.
key.
9 Settings
key.
.
.
: appears on the display
. This is the current value of X for
or
. This is the current value of Y
or
key.
.
.
appears on the display
key
key
57