Return To The Factory Settings; Carrying Out An Auto-Detect - REMEHA Quinta Pro series Installation, User And Service Manual

Fig.51 Resetting factory settings
3x
...x
Fig.52

Carrying out an auto-detect

3x
...x
123157 - v.06 - 24022015

9.2.4 Return to the factory settings

1. Press the two
until the symbol flashes in the menu bar.
2. Select the installer menu using the
3. Use the
4. To confirm, press the
: appears with a flashing
5. Press the
with a flashing
6. To confirm, press the
appears with a flashing
Check this against the value of X on the type plate.
7. Enter the value of X shown on the type plate using the
keys.
8. To confirm, press the
:
dU. Check this against the value of Y on the type plate.
9. Enter the value of Y shown on the type plate using the
keys.
10. To confirm, press the
The factory settings are reset.
11. The display returns to the current operating mode.
AD-0000078-01
9.2.5 Carrying out an auto-detect
After removing a PCB, an auto-detect must be carried out. Proceed as fol­
lows:
1. Press the two
until the symbol flashes in the menu bar.
2. Select the installer menu using the
3. Use the
4. To confirm, press the
: appears with a flashing
5. Press the
with a flashing
6. To confirm, press the
Auto-detect is carried out.
7. The display returns to the current operating mode.
AD-0000079-01
keys at the same time and then press the
appears on the display.
or keys to set the installer code
key.
.
key several times until
.
key.
. This is the current value of X for dF.
key.
appears with a flashing . This is the current value of Y for
key.
keys at the same time and then press the
appears on the display.
or keys to set the installer code
key.
.
key several times until
.
key.
9 Settings
key
key.
.
: appears on the display
or
or
key
key.
.
appears on the display
51