Restoring To Factory Settings; Activating The Manual Mode Menu - REMEHA Gas 210 ECO PRO Installation, User And Service Manual

6 Settings
Fig.7

Restoring to factory settings

4x
Fig.8 Activating manual mode
3x
2x
12
6.3.3 Restoring to factory settings
1. Navigate to the Installer menu.
The
2. Select the installer menu using the
The text
3. Using the
4. To confirm, press the
:
5. Press the
with a flashing
6. To confirm, press the
appears with a flashing
dF. Check this against the value of X on the type plate.
7. Enter the value of X shown on the type plate using the
8. To confirm, press the
:
for dU. Check this against the value of Y on the type plate.
9. Enter the value of Y shown on the type plate using the
10. To confirm, press the
The factory settings are reset.
11. The display shows the main display.
AD-4000055-01
6.3.4

Activating the manual mode menu

In some cases, it may be necessary to set the boiler to manual mode, for
example when the regulator has not yet been connected.
1. Navigate to the manual mode menu.
The
2. Press the
The minimum flow temperature value appears on the screen.
3. Press the
mode.
4. To confirm, press the
The boiler is now set to manual mode.
5. Press the
main display.
AD-4000050-01
symbol flashes in the menu bar.
{7}{8}{9}{10}{11}{12} flashes in the display.
or keys, set the installer code
key.
appears with a flashing .
key several times until
.
key.
. This is the current value of X for
key.
appears with a flashing
key.
symbol flashes in the menu bar.
key to open the menu.
or key to temporarily change this value in manual
key.
key twice to stop manual mode and to go back to the
key.
.
: appears on the display
or
. This is the current value of Y
or
7698035 - v.01 - 19022018
key.
key.