Configuring Ldap Servers - AudioCodes Mediant 800B User Manual

Parameter
DN Search Method
search-dn-method
[LdapServerGroups_SearchDnsMet
hod]
Cache
Cache Entry Timeout
cache-entry-timeout
[LdapServersGroups_CacheEntryTi
meout]
Cache Entry Removal Timeout
cache-entry-removal-
timeout
[LdapServerGroups_CacheEntryRe
movalTimeout]

15.4.4 Configuring LDAP Servers

The LDAP Servers table lets you configure up to four LDAP servers. The table defines the
address and connectivity settings of the LDAP server. The LDAP server can be configured
for SIP-related queries (e.g., routing and manipulation) or LDAP-based management user
login authentication and authorization (username-password).
The following procedure describes how to configure an LDAP server through the Web
interface. You can also configure it through ini file (LdapConfiguration) or CLI (configure
system > ldap ldap-configuration).
Note: When you configure an LDAP server, you need to assign it an LDAP Server
Group. Therefore, before you can configure an LDAP server in the table, you must
first configure at least one LDAP Server Group in the LDAP Server Groups table (see
'Configuring LDAP Server Groups' on page 242).

To configure an LDAP server:
1. Open the LDAP Servers table (Setup menu > IP Network tab > RADIUS & LDAP
folder > LDAP Servers).
User's Manual
Defines the method for querying the Distinguished Name (DN)
objects within each LDAP server.

[0] Sequential = (Default) The query is done in each DN
object, one by one, until a result is returned. For example, a
search for the DN object record "JohnD" is first run in DN
object "Marketing" and if a result is not found, it searches in
"Sales", and if not found, it searches in "Administration", and
so on.

[1] Parallel = The query is done in all DN objects at the
same time. For example, a search for the DN object record
"JohnD" is done at the same time in the "Marketing", "Sales"
and "Administration" DN objects.
Defines the duration (in minutes) that an entry in the device's
LDAP cache is valid. If the timeout expires, the cached entry is
used only if there is no connectivity with the LDAP server.
The valid range is 0 to 35791. The default is 1200. If set to 0,
the LDAP entry is always valid.
Defines the duration (in hours) after which the LDAP entry is
deleted from the device's LDAP cache.
The valid range is 0 to 596. The default is 0 (i.e., the entry is
never deleted).
244
Mediant 800B Gateway & E-SBC
Description
Document #: LTRT-10298