MEcHANIcAL INSTALLATION
5.6.4 Mounting on the wall
•
•
•
•
•
Figure 20:
Wall mounting
ATTENTION
The cabinet system has a pull-out system for disassembling the drive converter.
If it is necessary to remove the drive converter, make sure that the cabinet system
is securely anchored to the wall.
The rear ring bolts must be removed for wall mounting.
At this point, the supplied mounting brackets must be mounted with the M12 x 25
fixing screws.
The hole diameter for wall mounting is 1 x 14 mm or 2 x 9 mm.
All supplied mounting brackets must be used for wall mounting.
51