Lightware UMX4x4-Pro User Manual page 75

list window, and also in the Last Attached Monitors EDIDs window. Changes can be
made only in the EDID list window.
Step 1. Click the desired monitor's EDID from the list.
Step 2. Click the Learn this EDID to submenu item. A popup window will show the memory
Step 3. Click on the desired memory location. The lists are refreshed in a few seconds, and
Step 4. If the EDID learning was successful a reply message will be appeared on the lower
Section 6. Web control – Using built-in website
locations from 90 to 139, which are available for the user.
a message box indicates the change.
left corner.
Figure 6-7. Learning EDID from display device
UMX4x4-Pro
User's Manual
Page 75 / 129