Lightware UMX4x4-Pro User Manual page 117

Table of Contents

Advertisement

UMX4x4-Pro
User's Manual
Figure 8-6. Selecting new firmware files
Step 7. Enable the upgrade and Quick Bootload mode
After selecting the new firmware file, you must enable the upgrade by clicking the checkbox
left to the controller type (marked with a red circle in the picture below). You may enable
Quick Bootload mode by clicking the checkbox next to it (marked with a red rectangle in
the picture below). Quick Bootload mode speeds up the process by not reading back the
written data, only verifying the checksum. It can be enabled and disabled any time during
the upgrade process.
Section 8. Firmware upgrade
Page 117 / 129

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UMX4x4-Pro and is the answer not in the manual?

Table of Contents