Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
Applicable Environment
To enable users to communicate through the ISP network, user packets are added an outer VLAN
tag.
Pre-configuration Tasks
None
Data Preparation
To configure selective QinQ, you need the following data.
No.
1
2
3
5.4.2 Setting the Link Type of an Interface
Context
Do as follows on the S7700 to be configured with selective QinQ:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
port link-type hybrid
The link type of the interface is set to hybrid.
By default, the link type of an interface is hybrid.
----End
5.4.3 Adding an Outer VLAN Tag
Context
Do as follows on the S7700 where you need to configure selective QinQ.
Issue 01 (2011-07-15)
Data
Number of the interface to be configured with selective QinQ
Inner VLAN ID
Outer VLAN ID
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 QinQ Configuration
193