Configuring Gvrp; Establishing The Configuration Task; Enabling Gvrp - Huawei Quidway S7700 Configuration Manual - Ethernet

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet

6.3 Configuring GVRP

This section describes how to configure the GVRP function.

6.3.1 Establishing the Configuration Task

Applicable Environment
On a complicated Layer 2 network, you can enable interfaces to dynamically join or leave
VLANs by configuring the GVRP function. This simplifies the configuration
Pre-configuration Tasks
Before configuring the GVRP function, complete the following task:
l
Data Preparation
To configure the GVRP function, you need the following data.
No.
1
2

6.3.2 Enabling GVRP

Context
Do as follows on the S7700 to enable GVRP.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
gvrp
GVRP is enabled globally.
Step 3 Run:
interface interface-type interface-number
The interface view is displayed.
Issue 01 (2011-07-15)
Adding the GVRP interfaces to all VLANs
Data
(Optional) Registration mode of GVRP interfaces
(Optional) Values of GARP timers
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 GVRP Configuration
334