Link Aggregation Configuration - Huawei Quidway S7700 Configuration Manual - Ethernet

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
About This Chapter
This chapter describes the concepts, configuration procedures, and configuration examples of
link aggregation.
2.1 Introduction to Link Aggregation
This section describes the concept of link aggregation.
2.2 Link Aggregation Supported by the S7700
This section describes link aggregation features supported by the S7700.
2.3 Configuring Link Aggregation in Manual Load Balancing Mode
This section describes how to configure link aggregation in manual load balancing mode.
2.4 Configuring Link Aggregation in Static LACP Mode
This section describes how to configure link aggregation in static LACP mode.
2.5 Configuring an Eth-Trunk Sub-interface
This section describes how to configure an Eth-Trunk sub-interface.
2.6 Configuring an E-Trunk
As an extension to the Link Aggregation Protocol (LACP) that implements link aggregation on
a single device, the Enhanced Trunk (E-Trunk) protocol implements link aggregation between
different devices. This improves link reliability between devices.
2.7 Maintaining Link Aggregation
This section describes how to clear the statistics of received and sent LACP packets, debug the
link aggregation group, and monitor the running status of the link aggregation group.
2.8 Configuration Examples
This section provides several configuration examples of link aggregation in manual load
balancing mode and in static LACP mode.
Issue 01 (2011-07-15)
2

Link Aggregation Configuration

Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Link Aggregation Configuration
17