Huawei Quidway S7700 Configuration Manual - Ethernet page 291

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
CE1
CE2
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
7.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Configure the VLANs that the interfaces belong to according to
The configuration procedure is not mentioned.
Step 2 Configure selective QinQ on the interfaces of the switches and specify the VLANs allowed by
the interfaces.
# Configure Switch1.
[Switch1] vlan 100
[Switch1-vlan100] quit
[Switch1] interface gigabitethernet 2/0/0
[Switch1-GigabitEthernet2/0/0] port hybrid tagged vlan 100
[Switch1-GigabitEthernet2/0/0] quit
[Switch1] interface gigabitethernet 1/0/0
[Switch1-GigabitEthernet1/0/0] port hybrid untagged vlan 100
[Switch1-GigabitEthernet1/0/0] port vlan-stacking vlan 10 stack-vlan 100
[Switch1-GigabitEthernet1/0/0] quit
Issue 01 (2011-07-15)
GigabitEthernet1/0/0
GigabitEthernet1/0/0
Configure the routing protocol on the backbone network to implement interworking.
Set up a remote LDP session between the PEs.
Set up a tunnel between the PEs to transmit user data.
Enable MPLS L2VPN on the PEs.
Create VSIs on PEs, specify LDP as the signaling protocol, and bind the VSI to related AC
interfaces.
Configure QinQ sub-interfaces on the PE interfaces connected to the switches and connect
the QinQ sub-interfaces to the VPLS network.
Configure selective QinQ on the switch interfaces connected to CEs.
VSI name and VSI ID
IP addresses of peers and tunnel policy used for setting up the peer relationship
Interfaces to which the VSI is bound
Encapsulation mode of the sub-interfaces and VLANs that the sub-interfaces belong to
NOTE
l The AC-side physical interface and PW-side physical interface of a PE cannot be added to the same
VLAN; otherwise, a loop occurs.
l After the configuration, the packets sent from a CE to a switch should contain a VLAN tag.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
VLANIF 10
VLANIF 10
Figure
5 QinQ Configuration
10.1.1.1/24
10.1.1.2/24
5-12.
274