Optional) Assigning An Ip Address To An Ethernet Sub-Interface; Checking The Configuration - Huawei Quidway S7700 Configuration Manual - Ethernet

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
virtual-cable-test
A cable test is performed on the interface.
----End
1.4.10 (Optional) Assigning an IP Address to an Ethernet Sub-
interface
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number.subinterface-number
An Ethernet sub-interface is created and the Ethernet sub-interface view is displayed.
Step 3 Run:
ip address ip-address { mask | mask-length } [ sub ]
The IP address of the Ethernet sub-interface is configured.
Only the E-series and F-series boards supports the configuration of sub-interfaces.
----End

1.4.11 Checking the Configuration

Procedure
l
l
l
----End
Issue 01 (2011-07-15)
NOTE
l The test result is only for reference.
l Running the virtual-cable-test command may affect services on the interface in a short period of time.
l Before performing a cable test, shut down the remote interface or remove the network cable from the
remote interface. Otherwise, signals from the remote interface may make the test result inaccurate.
Run the display port-group [ all | port-group-name ] command to check information about
a port group.
Run the display interface [ interface-type [ interface-number [.subnumber ] ] ] command
to check information about auto-negotiation capability on an Ethernet interface.
Run the display virtual-cable-test interface-type interface-number command to check the
cable test result on an Ethernet interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Ethernet Interface Configuration
13