Huawei Quidway S7700 Configuration Manual - Ethernet page 284

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
Figure 5-11 Networking diagram for configuring Martini VPLS
PE 1
GE1/0/0
GE1/0/0
Switch
PE1
PE2
P
CE1
CE2
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
Data Preparation
To complete the configuration, you need the following data:
Issue 01 (2011-07-15)
Loopback1
1.1.1.9/32
GE 2/0/0
CE 1
Interface
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet1/0/0
Configure the routing protocol on the backbone network to implement interworking.
Set up a remote LDP session between the PEs.
Set up a tunnel between the PEs to transmit user data.
Enable MPLS L2VPN on the PEs.
Create VSIs on PEs, specify LDP as the signaling protocol, and bind the VSI to related AC
interfaces.
Configure dot1q sub-interfaces on the PE interfaces connected to CEs and connect the dot1q
sub-interfaces to the VPLS network.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Loopback1
2.2.2.9/32
GE 2/0/0
GE 1/0/0
P
Martini
VLANIF interface
GigabitEthernet1/0/0.1
VLANIF 20
-
VLANIF 30
GigabitEthernet2/0/0.1
-
VLANIF 20
VLANIF 30
-
VLANIF 10
VLANIF 10
5 QinQ Configuration
Loopback1
3.3.3.9/32
PE 2
GE1/0/0
GE 2/0/0
GE 1/0/0
CE 2
IP address
-
168.1.1.1/24
1.1.1.9/32
169.1.1.2/24
-
3.3.3.9/32
168.1.1.2/24
169.1.1.1/24
2.2.2.9/32
10.1.1.1/24
10.1.1.2/24
267