Example For Configuring The Dot1Q Sub-Interfaces To Access Vll - Huawei Quidway S7700 Configuration Manual - Ethernet

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
5.12.6 Example for Configuring the Dot1q Sub-interfaces to Access
VLL
Networking Requirements
As shown in
VLANs.
A Martini VLL is set up between CE1 and CE2.
Figure 5-6 Networking diagram for configuring a Martini VLL
GE1/0/0
GE1/0/0
Switch
PE1
PE2
P
CE1
CE2
Configuration Roadmap
The configuration roadmap is as follows:
1.
Issue 01 (2011-07-15)
Figure 5-6, CE1 and CE2 are connected to PE1 and PE2 respectively through
Loopback1
1.1.1.9/32
PE 1
GE 2/0/0
CE 1
Interface
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet1/0/0
Configure the routing protocol on devices (PE and P) of the backbone network to implement
interworking and enable MPLS.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Loopback1
2.2.2.9/32
GE 2/0/0
GE 1/0/0
P
Martini
Layer 3 interface
GigabitEthernet1/0/0.1
VLANIF 20
-
VLANIF 30
GigabitEthernet2/0/0.1
-
VLANIF 30
VLANIF 20
-
VLANIF 10
VLANIF 10
5 QinQ Configuration
Loopback1
3.3.3.9/32
PE 2
GE1/0/0
GE 2/0/0
GE 1/0/0
CE 2
IP address
-
10.1.1.1/24
1.1.1.9/32
10.2.2.1/24
-
3.3.3.9/32
10.2.2.2/24
10.1.1.2/24
2.2.2.9/32
100.1.1.1/24
100.1.1.2/24
232