Configuring Vlan Stacking Based On The Vlan Priority On The Incoming Interface; Optional) Configuring Vlan Priority Mapping On The Outbound Interface - Huawei Quidway S7700 Configuration Manual - Ethernet

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
No.
1
2
3
4
5
5.6.2 Configuring VLAN Stacking Based on the VLAN Priority on
the Incoming Interface
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
port hybrid untagged vlan vlan-id
The interface is added to the VLAN specified by vlan-id.
Step 4 Run the following commands as required.
l To configure VLAN stacking based on the VLAN priority on the incoming interface, run
l To configure VLAN stacking based on the VLAN ID and VLAN priority on the incoming
VLAN stacking based on the VLAN priority is supported only on the E-series and F-series
boards.
----End
5.6.3 (Optional) Configuring VLAN Priority Mapping on the
Outbound Interface
Procedure
Step 1 Run:
Issue 01 (2011-07-15)
Data
Number of the incoming interface and outgoing interface of packets
VLAN ID and 802.1p priority of the incoming interface before VLAN stacking is
configured
VLAN ID and internal priority of the incoming interface after VLAN stacking is
configured
Internal priority of the outgoing interface before VLAN mapping is configured
802.1p priority of the outgoing interface before VLAN mapping is configured
port vlan-stacking 8021p 8021p-value stack-vlan vlan-id.
interface, run port vlan-stacking vlan vlan-id1 [ to vlan-id2 ] 8021p 8021p-value1 [ to
8021p-value2 ]stack-vlan vlan-id3 [ remark-8021p 8021p-value3 ].
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 QinQ Configuration
199