Huawei Quidway S7700 Configuration Manual - Ethernet page 307

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
# Configure PE2.
[PE2] interface gigabitethernet 2/0/0.1
[PE2-GigabitEthernet2/0/0.1] control-vid 2000 qinq-termination
[PE2-GigabitEthernet2/0/0.1] qinq termination pe-vid 200 ce-vid 10
[PE2-GigabitEthernet2/0/0.1] l2 binding vsi a2
[PE2-GigabitEthernet2/0/0.1] quit
Step 9 Assign IP addresses to VLANIF interfaces on the CEs.
# Configure CE1.
<Quidway> sysname CE1
[CE1] interface vlanif 10
[CE1-Vlanif10] ip address 10.1.1.1 255.255.255.0
[CE1-Vlanif10] quit
# Configure CE2.
<Quidway> sysname CE2
[CE2] interface vlanif 10
[CE2-Vlanif10] ip address 10.1.1.2 255.255.255.0
[CE2-Vlanif10] quit
Step 10 Verify the configuration.
After the configuration, run the display vsi name a2 verbose command on PE1, and you can
find that VSI a2 sets up a PW to PE2, and the status of the VSI is Up.
<PE1> display vsi name a2 verbose
***VSI Name
CE1 (10.1.1.1) can ping CE2 (10.1.1.2) successfully.
<CE1> ping 10.1.1.2
PING 10.1.1.2: 56
Issue 01 (2011-07-15)
Administrator VSI
Isolate Spoken
VSI Index
PW Signaling
Member Discovery Style : static
PW MAC Learn Style
Encapsulation Type
MTU
Mode
Service Class
Color
DomainId
Domain Name
VSI State
VSI ID
*Peer Router ID
VC Label
Peer Type
Session
Tunnel ID
Interface Name
State
**PW Information:
*Peer Ip Address
PW State
Local VC Label
Remote VC Label
PW Type
Tunnel ID
data bytes, press CTRL_C to break
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: a2
: no
: disable
: 0
: ldp
: unqualify
: vlan
: 1500
: uniform
: --
: --
: 0
:
: up
: 2
: 3.3.3.9
: 23552
: dynamic
: up
: 0x20021,
: Vlanif10
: up
: 3.3.3.9
: up
: 23552
: 23552
: label
: 0x20021,
5 QinQ Configuration
290