Huawei Quidway S7700 Configuration Manual - Ethernet page 263

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
PE1
PE2
P
CE1
CE2
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Specify the VLANs that the interfaces of CEs, PEs, and P belong to and set the IP addresses of
the corresponding VLANIF interfaces according to
After the configuration, the packets sent from a CE to a switch should contain a VLAN tag.
The configuration procedure is not mentioned.
Issue 01 (2011-07-15)
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet1/0/0
Configure the routing protocol on devices on the backbone network (PE and P) to
implement interworking and enable MPLS.
Use the default tunnel policy to create an LSP and configure the LSP as the tunnel for data
transmission.
Enable MPLS L2VPN and create VC connections on the PEs.
Configure VLAN mapping of a single tag on the sub-interface of the PE1 interface
connected to CE1 and connect the sub-interface to the VLL.
Configure a dot1q sub-interface on the PE2 interface connected to CE2 and connect the
dot1q sub-interface to the VLL.
Name of the remote peer of each PE
VC ID
VLAN IDs used in VLAN mapping
Encapsulation mode of the sub-interfaces and VLANs that the sub-interfaces belong to
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GigabitEthernet1/0/0.1
VLANIF 20
-
VLANIF 30
GigabitEthernet2/0/0.1
-
VLANIF 30
VLANIF 20
-
VLANIF 10
VLANIF 20
Figure 5-8.
5 QinQ Configuration
-
10.1.1.1/24
1.1.1.9/32
10.2.2.1/24
-
3.3.3.9/32
10.2.2.2/24
10.1.1.2/24
2.2.2.9/32
100.1.1.1/24
100.1.1.2/24
246