Example For Configuring Vlan Aggregation - Huawei Quidway S7700 Configuration Manual - Ethernet

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
Configuration Files
Configuration file of the Switch
#
sysname Quidway
#
vlan-switch name1 interface GigabitEthernet1/0/1 vlan 10 interface
GigabitEthernet1/0/2 switch-vlan 20
#
return

3.12.10 Example for Configuring VLAN Aggregation

This part describes how to configure communication between VLANs with less IP addresses.
Networking Requirements
Assume that an enterprise has many departments and IP addresses of these departments are on
the same network segment, to improve the service security, IP address of employee users in
different departments are added to different VLANs. Employee users in different departments
need to communicate with each other.
As shown in
different VLANs. It is required that employee users in different VLANs communicate with each
other.
Figure 3-19 Network diagram of VLAN aggregation
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Issue 01 (2011-07-15)
Figure 3-19, IP addresses of the R&D department and test department belong to
Switch
GE1/0/0
GE2/0/0
VLAN2
VLAN2
Add interfaces of the Switch to sub-VLANs.
Add the sub-VLANs to a super-VLAN.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE3/0/0
GE4/0/0
VLAN3
VLAN4
VLANIF4:100.1.1.12/24
VLAN3
3 VLAN Configuration
142