Operation
5.3 Menu control
5.3.3
Jump back to coded/decoded display mode
With the [MEAS] key, you can jump from "Operator control mode" back to "Decoded display
mode". Any input started is aborted.
Before jumping back, the following query appears:
Return to measuring
Accept modifications?
Figure 5-6
● Press "YES" to accept changes permanently into the working memory of the parameter
● Press [ESC] to return to the last function screen. Changes are accepted here without a
Coding the device
After jumping back to "Decoded display mode" with [ESC] or [MEAS], if you press [MEAS]
again you put the device back into "Coded display mode". Only now is the functional check
deactivated again.
5.3.4
Fast function selection
In order to directly access the desired function when operating frequently from the "Coded
display mode", a "Power user operation" was created. This allows you to directly access the
desired function by entering the function number. This allows you to skip menu levels.
However, the functions can only be directly called from the measured value display. For fast
function selection, proceed as follows:
1. Enter the number of the desired function using the number keys.
2. Press the softkey of the component with the arrow ►. If the desired function is protected
See also
Overview of operating functions (Page 51)
50
Query before jumping back
memory or "NO" to discard the changes. The device then changes to "Decoded display
mode".
further query.
by a code, you will be asked to enter the code.
O
2
YES
NO
Operating Instructions, 06/2008, A5E00880383-03
OXYMAT 64