Registration Motor - Ricoh D104 Field Service Manual

When the result of this adjustment is "2" or "3":
• Check that the all PCDUs are correctly set and that the ITB unit is correctly set.
• Do "Drum Phase Adj." again after checking the PCDUs and ITB unit.
When the result is still "2" or "3" after checking the PCDUs and image transfer belt unit:
• Check that the gear unit is installed correctly.
5. Exit the SP mode.

Registration Motor

1. Rear cover ( p.168)
2. Rear lower cover (
3. Open the controller box (
4. Registration motor [A] (
• The short screwdriver (190 mm or less in total length) is required to remove the screw [B]
• The picture below shows how to remove the screw [C] of the gear unit. The controller box should
be closed at this time.
p.168)
p.294 "Controller Box")
x 2, x 1)
Drive Unit
4
235