Ricoh D104 Field Service Manual page 771

[Heat Storage Status] DFU
1114
These SPs are desgined for the factory use only. Do not change the adjusted setting.
Temp.:Threshold: Press
001
Specifies the threshold temperature of the pressure roller for the heat storage status.
Temp.:Threshold:
Atmosphere
002
Specifies the threshold temperature inside the machine for the heat storage feedback control.
[Target Temp. Correction] DFU
1115
This SP is desgined for the factory use only. Do not change the adjusted setting.
Temp.:Delta:End
001
Specifies the different temperature between end and center of the heating roller.
1116 [Press Temp. FB Control]
Execution mode
001
Selects the heat storage FB control mode.
Usage Limitation:
Use "0: OFF" or "1: ON: BW" only.
DFU
-011
The following SPs below are desgined for the factory use only. Do not change the adjusted
to -106
setting.
011 Time Out
021 Delay:Standard Speed:FC:1 *ENG
Delay:Standard Speed:BW:
022
1
025 Delay:Low Speed:FC:1
026 Delay:Low Speed:BW:1
031 Delay:Standard Speed:FC:2 *ENG
*ENG [0 to 200 / 80 / 1 deg/step]
*ENG [0 to 200 / 80 / 1 deg/step]
*ENG [-10 to 100 / 0 / 1 deg/step]
[0 to 2 / 1 / 1 /step]
*ENG
0: OFF, 1: ON: BW, 2: ON: BW/FC
*ENG [0 to 500 / 5 / 1 sec/step]
[0 to 20,000 / 0 / 1 msec/step]
*ENG [0 to 20,000 / 0 / 1 msec/step]
*ENG [0 to 20,000 / 0 / 1 msec/step]
*ENG [0 to 20,000 / 0 / 1 msec/step]
[0 to 20,000 / 0 / 1 msec/step]
System SP1-xxx
3
53