Ricoh D104 Field Service Manual page 468

5. System Maintenance
Selects the brand name and the production name for Windows Plug & Play. This information
is stored in the NVRAM. If the NVRAM is defective, these names should be registered again.
001
After selecting, press the "Original Type" key and "#" key at the same time. When the setting
is completed, the beeper sounds five times.
5913 [Switchover Permission Time]
Print Application Timer
002
Sets the amount of time to elapse while the machine is in standby mode (and the operation
panel keys have not been used) before another application can gain control of the display.
5967 [Copy Server Set Function]
5
Enables and disables the document server. This is a security measure that prevents image
001 data from being left in the temporary area of the HDD. After changing this setting, you must
switch the main switch off and on to enable the new setting.
[Cherry Server]
5974
Specifies which version of ScanRouter, "Lite" or "Full", is installed.
001 Cherry Server
[Device Setting]
The NIC and USB support features are built into the GW controller. Use this SP to enable
5985
and disable these features. In order to use the NIC and USB functions built into the controller
board, these SP codes must be set to "1".
001 On Board NIC
466
*CTL [3 to 30 / 3 / 1 second /step]
*CTL 0: ON, 1: OFF
[0 or 1 / 0 / – ]
*CTL
0: Lite, 1: Full
[0 to 2 / 0 / 1 /step]
0: Disable, 1: Enable, 2: Function limitation
When the "Function limitation" is set, "On board NIC" is
limited only for the NRS or LDAP/NT authentication.
• Other network applications than NRS or LDAP/NT
authentication are not available when this SP is set to
"2". Even though you can change the initial settings of
those network applications, the settings do not work.