Ricoh D104 Field Service Manual page 141

4. Peel off the double-sided tapes on the Velcro fasteners [A], and then attach them at the front left and
rear left of the machine.
5. Attach "ANT1" (having a black ferrite core) [B] to the front left of the machine.
6. Attach "ANT2" (having a white ferrite core) [C] to the rear right of the machine.
• "ANT1" is a transmission/reception antenna and "ANT2" is a reception antenna. Do not attach
them at the wrong places.
7. Attach the clamps as shown above.
8. Wire the cables and clamp them (
• Make sure that the cables are not slack. Keep them wired tightly along the covers.
You may have to move the machine if the reception is not clear.
• Make sure that the machine is not located near an appliance or any type of equipment that generates
strong magnetic fields.
• Put the machine as close as possible to the access point.
x 7).
Controller Options
2
139