Installation Requirements
Operating Environment
• Install the printer in a place meeting the following temperature and humidity requirements:
Temperature
Humidity
Maximum Wet-bulb Temperature : 25℃
• Be careful not to allow dew condensation to occur.
• When installing the printer in air of a humidity of 30% or less, use a humidifier or an antistatic mat.
Installation Warnings and Cautions
• Do not install the printer in an area that becomes hot or near fire.
• Do not install the printer in a place where a chemical reaction occurs (such as a laboratory).
• Do not install the printer near a flammable liquid, such as alcohol or a thinner.
• Do not install the printer within reach of children.
• Do not install the printer in an unstable surface (such as on unstable table or an
inclined surface).
• Do not install the printer in a damp or dusty place or an area exposed to direct
sunlight.
• Do not install the printer in salt air or a corrosive gas environment.
• Do not install the printer in a vibratory surface.
• Do not install the printer in an area where its air vent is blocked.
• Do not install the printer directly on a thick carpet.
• Do not install the printer in a poorly-ventilated area such as a closed room.
• When using the printer in a small room, pay attention to the air ventilation in the room.
• Install the printer away from strong magnetic fields and noise sources.
• Install the printer away from monitors and televisions.
• When carrying the printer, hold the handles on both sides.
• The printer should be lifted up by two or more persons.
Installation Space
• Do not place the printer on the ground; Put it on a flat table large enough for the printer's legs to be placed.
• Create enough space around the printer.
Top View
100cm
: 10 to 32℃
: 20 to 80% RH (relative humidity)
Side View
40cm
20cm
20cm
45cm
27cm
Installation Requirements
1
13