Table of Contents
Advertisement
Printing speed is slow.
Printing process is performed in the computer
as well.
[High Quality] is selected for [Quality] or [Print
Quality] in the printer driver.
The print data is complicated.
The printing process stops.
The printer cable is broken.
Time is out in the computer.
Abnormal sound is detected.
The printer is tilted.
There may be paper chips or foreign object in
the printer.
The top cover is open.
Printing does not start immediately. It takes a long time to start printing.
The printer is adjusting the temperature of the
fuser unit.
The printer is preheated after recovering from
the power saving mode.
The printer is preheated after recovering from
the sleep mode.
The printer is dealing with data transmitted
from other ports.
Printing is performed slowly, or stops halfway.
4 4
The fuser temperature has arisen due to
continuous printing etc., so the printer is
adjusting its temperature by performing
intermittent printing* and slowing down the
printing speed.
The printer internal temperature has arisen
due to long-time continuous printing in a
hot environment, so the printer is adjusting
its temperature by performing intermittent
printing*, slowing down the printing speed, or
suspending printing.
The fuser terminal temperature has arisen
when narrow paper (230 mm or less) is
printed, so the printer is adjusting the fuser
temperature by switching to intermittent
printing.
※ Intermittent printing is a printing method of printing at regular intervals.
122
Unable to Print
Use a computer with faster processing speed.
Specify [Normal] for [Quality] or [Print Quality] in the printer
driver. (User's Manual - Advanced)
Simplify the print data.
Replace the printer cable.
Set a longer timeout value.
Place the printer on a stable and flat surface.
Check inside the printer and remove them if any.
Close the top cover by pushing the center of the top cover.
14)
Please wait for a while.
Warm-up time can be shortened by setting [POWER SAVE] to
[DISABLE] in the Maintenance menu of the printer.
Warm-up time can be shortened by setting [SLEEP] to [DISABLE] in
the Maintenance menu of the printer.
Wait until the printing stops halfway.
Please wait for a while without turning off the power. The printer
starts normal printing when the temperature cools down to the level
suitable for normal printing.
Please wait for a while without turning off the power. The printer
starts normal printing when the temperature cools down to the level
suitable for normal printing.
Please wait for a while without turning off the power. The printer
starts normal printing when the temperature cools down to the level
suitable for normal printing.
(Page
13)
(Page
Advertisement
Table of Contents
