Mx500/Muc (Multiple Unit Control) - NorthStar MX500 Operator's & Installation Manual

Operator's Manual
Note: LAN port must be setup before enabling this feature. The
units can be connected over an Ethernet cross-over cable or using
an Ethernet switch. See page 118 of this manual for instructions to
setup LAN.
MX Smart GPS Antenna

MX500/MUC (Multiple Unit Control)

This is a multiple unit control CDU system where one MX 500 oper-
ates as a master, at least one (maximum of two) MX 500 operates as
a slave, and up to three (if any) MX 500 operate as a repeater are
supplied. The multiple unit control CDU system must contain a mini-
mum of three MX 500 and a maximum of five MX 500 units alto-
gether. Only one smart DGPS antenna is required. The antenna unit
is connected only to the MX500 master unit.
Note: LAN port must be setup before enabling this feature. The
units must be connected together using an Ethernet switch. See page
118 of this manual for instructions to setup LAN.
8
(Host)
MX 422 Profe s sio nal DG P S N avigator
MX500 CDU
Master unit
MX500/BRIM System Configuration
Functional Description
MX Smart GPS Antenna
(Client 1)
MX 422 Profe s sio nal DGP S N avigator
LAN
MX500 CDU
Slave unit
Version 3.0