NorthStar MX500 Operator's & Installation Manual page 157

Configuration
Here is a sample of the Brief format without an active route:
Here is a sample of the Brief format with an active route or MOB
condition:
Sending: Causes the printer output to be turned On or Off (default).
Print Interval (Sec): Allows you to control how often the print out will
Format: Allows you to choose either the Full or Brief formats de-
Bit Rate: This allows you to control the port interface baud rate to
Data Bits: This allows you to match the printer's requirement of 7 or 8
Stop Bits: This allows you to match the printer's requirement of 1
Parity Check: This allows you to match the printer's requirement of
Handshake: This allows you to match the printer's requirement of No
Version 3.0
Northstar
====================================
21:24:00 UTC
POS Mode : DGPS 3D
POS: N 33 48.5124
COG: 152T SOG: 0.1 Kn
------------------------------------
Northstar
====================================
21:24:00 UTC
POS Mode : DGPS 3D
POS: N 33 48.5124
COG: 152T SOG: 0.1 Kn
BRG: 239T Dist: 27.4 Nm XTE:0.14L Nm
RTE: RL From WPT 1234 To WPT 1357
-------------------------------------------------------------------------
be sent to the printer port. The default value is 60 seconds, and the
valid range is from 1 to 9999 seconds.
scribed above.
match the printer or computer you are interfacing with. The avail-
able baud rates are: 600, 1200, 2400, 4800 (default), 9600 or 19,200.
(default) bit serial data.
(default) or 2 stop bits.
None (default), Even or Odd parity.
(default), XON/XOFF or HW (Hardware; CTS, RTS ).
MX500
12 Apr 2002
Datum:W84
W 118 21.0213
MX500
11 Aug 1997
Datum:W84
W 118 21.0213
Operator's Manual
Navigator
Navigator
143