Creating And Editing Waypoints - NorthStar MX500 Operator's & Installation Manual

Waypoint

Creating and Editing Waypoints

When editing a waypoint, you are always prompted to select the ap-
propriate datum. You might occasionally see a prompt warning you
that the waypoint is used either in a stored route or the active route.
You ultimately have the final decision whether to continue editing
the waypoint, or exiting this waypoint by pressing the EDIT key again
to exit the edit mode.
Creating and editing waypoints is easy.
1. Select the WPT key until the WPT1 screen is displayed.
2. Press the EDIT key.
3. Highlight the Make New WPT softkey and press ENT or align the
Version 3.0
For example, if you are looking for the LA HARBOR EN-
TRANCE and you enter HAR, the screen will display all
waypoints with these three characters in this exact order.
cursor with the waypoint you want to modify and highlight the
Edit this WPT softkey then press ENT.
Operator's Manual
53