Table of Contents
Advertisement
Installation Notes
MX500 NAVIGATOR INSTALLATION
The Navigator or CDU is the primary unit with the integrated display
and keypad. The navigator can be mounted using one of two tech-
niques:
•
Gimbal mount (supplied)
•
Frame mount (optional)
Each of these techniques are described below. All the hardware neces-
sary to complete Gimbal mount is provided with the MX500. You will
need rear panel access to complete these types of mounts. The Frame
mount is an option for applications where front panel removal is not
desired or rear panel access is not available. The hardware necessary
for the Frame mount is sold separately. It is important to consider the
space behind the unit to prevent sharp cable bends before commencing
with the installation. A minimum of 100 mm. free space is needed be-
hind the unit for cable dressing.
Gimbal Mounting
A pivot Mounting Bracket including finger screws are supplied with the
MX500. Use the two machine screws with the large palm grips to se-
cure the MX500 to the mounting bracket. To adjust the viewing angle,
lossen the side crews and then adjust the tilt angle of the display.
Flush Mount Frame
An optional Flush Mounting Frame is available. First, survey and mark-
out the location where the unit is to be mounted. Make sure there is a
minimum clearance of 200 mm behind the panel. Cut the mounting hole
as shown on Figure 3.5. Mount the MX 500 to the mounting frame.
Attach all the cable interfaces to the appropriate connectors. Finally,
mount the entire assembly to the panel from the display side.
Turning Power On and Off
The navigator is turned on by briefly pressing the
not keep the key pressed for more than one second, as this will turn the
navigator off again when the key is released. This key is also used to
turn the power off by either of two methods:
a) Software Control:
Pressing the
boxes (Yes and No). Respond Yes by pressing the ENT key to turn
Version 3.0
key momenbtarily will display the softkey option
Installation Manual
key. Please do
211
Advertisement
Table of Contents
Troubleshooting
