Datum - Current Position Calculation - NorthStar MX500 Operator's & Installation Manual

Operator's Manual
MX575:

Datum - Current Position Calculation

This screen controls which datum the receiver uses to display any
position. There are over 100 datums to choose from. Appendix A pro-
vides a complete list of available datums. You can enter an offset to
WGS-84 if your specific datum is not provided for in the receiver. Use
the Previous or Next softkeys or the cursor key to scroll through the
list until you find the datum you need. Highlight Escape then press
ENT to go back to the original datum displayed when you first pressed
the EDIT key.
110
Specify the input NMEA 0183 record for the Input Sentence.
HDT, HDG, HDM, HCC, HCD, VHW, or Any.
Set the constant MX575 Heading Offset (or bias) if any. If the
MX575 is used as a positioning and heading device, set Data
input port no to 3. If the MX575 is used as a heading device
only, set Data input port no to any available port (1 or 2) other
than port 3 (See MX575 Satellite Compass Installation &
Operation Manual for details).
Configuration
Version 3.0