Wpt & Rte Input - Uploading Waypoints Into The Receiver - NorthStar MX500 Operator's & Installation Manual

Operator's Manual
Wpt & Rte Input - Uploading Waypoints into the Receiver
This screen enables the input data port to receive waypoints and routes
from a chart plotter, PC (VMS), or other device to the receiver. You can
receive this data through any of the user NMEA 0183 input data ports.
Load the WPL sentences first, then the RTE sentences. Change Trans-
ducer Connected from No (default) to Yes and select the appropriate
port. Refer to the Waypoints - Uploading Waypoints from Other De-
vices section of this manual for more details on the software interface.
Refer to the Appendix F of this manual for hardware interface.
Note: Turn the WPT & RTE In option to No after the waypoint and
route banks have been downloaded to prevent an inadvergent
change of the MX 500 memory bank.
150
Configuration
Version 3.0