Eta Setup - NorthStar MX500 Operator's & Installation Manual

Operator's Manual

ETA Setup

If you choose to use this function, it is probably better to operate the
unit in UTC time mode if you are going to cross one or more time
zones. Note that the time entered uses the offset to UTC applied in
the CFG1 Time display.
The software calculates Estimated Time of Arrival based on how you
configure the unit. ETA settings are controlled from the RTE1 screen.
To change the ETA settings:
1. Select the RTE key until the RTE1 screen is displayed.
2. Press the EDIT key.
3. Highlight the ETA/SOG Calc. softkey and press ENT.
4. Highlight the Change softkey and press ENT to select which value
48
you want the CDU to calculate, either ETA based on speed, or
speed (SOG) based on desired time and date of arrival.
Route
Version 3.0