NorthStar MX500 Operator's & Installation Manual page 38

Operator's Manual
allow you to customize the information presented.
If you drift outside of your cross-track error limit and you decide not
to return to your original course line, you can reset your course line
from your present position to the waypoint by highlighting the Reset
XTE softkey from the display, and pressing the ENT key.
The Skip Waypoint softkey allows you to skip the waypoint you are
presently going to, and advance to the next waypoint. For example, if
you were under way and nearing waypoint 5 and you decide you
want to go on to waypoint 6 now, press the EDIT key, highlight the
Skip Waypoint softkey, and press the ENT key. If you make a mistake
and you want to go back (unskip) to waypoint 5, you can do this by
the following:
1. Go into the RTE1 screen.
2. Press EDIT in the RTE1 screen.
3. Highlight the Route Control softkey and press ENT.
4. Highlight the up arrow softkey (fourth from the left) and press
ENT
5. Press the EDIT key again.
Refer to the Route section of this manual for more details about skip-
ping and unskipping waypoints.
24
View - allows you to adjust the display for a Close (zoomed-in)
or a Far (zoomed-out) representation of your route.
Show Waypoints - allows you to turn waypoints which are not
part of the active route on and off.
Show Active Route - allows you to turn the course line on or off
on the display (assuming a symbol is entered for the first charac-
ter of the waypoint name).
Show Off Track Limit - allows you to turn the cross-track error
limit lines on or off on the display.
Show Data Window - allows you to select between the two NAV
1 display types depicted at the beginning of this section, one in
which the data is displayed in various parts of the graphic screen,
the other in which the data is displayed in a separate window to
the left of the graphic screen.
once.
Navigate
Version 3.0