Insert New Waypoint - NorthStar MX500 Operator's & Installation Manual

Route
6. When you have found the waypoint you want, press the Insert this
7. When you are finished, select the Done softkey to get back to the
8. You can then choose to select another waypoint using the same
9. Don't forget to press the EDIT key to end your editing.

Insert New Waypoint

The following example assumes RTE1 is empty. Follow the direc-
tions in the Erasing an Existing Route section to start with an empty
route if you have waypoints in the RTE1 screen.
1. Select the RTE key until the RTE1 screen is displayed.
2. Press the EDIT key to enter the edit mode.
3. Highlight Insert softkey from the display and press ENT. Skip to
4. Highlight Insert new Waypoint softkey from the display and press
Version 3.0
WPT softkey.
main menu.
method, select Escape to go back one level and use another method
to enter waypoints, or select Done do go back to the main menu.
the next step if RTE1 is empty.
ENT.
Operator's Manual
41