NorthStar MX500 Operator's & Installation Manual page 247

Installation Notes
19. Perform a Cold Start on the MX 500 unit by powering it off,
pressing and holding down the CLR key, and powering it back
on.
(Release the 'CLR' key after the unit is powered back on.)
20. Close the MX 500 Series Software Update program. Go back
to Step 1 to install software into another MX 500 unit.
21. If you are completely done and no longer want to install soft
ware into the MX 500 units, follow Steps 3-5 to get back to the
Internet Protocol (TCP/IP) Properties page. Select Obtain an
IP address automatically and Obtain DNS server address
automatically.
Click OK when finish. Disconnect the Ethernet cross-over cable
from both the PC and the MX 500 unit. If there is an Ethernet
cable connected to your PC prior to this setup, connect it back
in.
Version 3.0
Installation Manual
233