Insert Route - NorthStar MX500 Operator's & Installation Manual

Operator's Manual
5. Choose either Bearing, Distance or Lat/Lon (Grid Point, or TD if
6. When the information is correct, highlight the Done softkey and
7. You can then choose to enter another waypoint using the same
8. Don't forget to press the EDIT key to end your editing.

Insert Route

The following example assumes RTE1 is empty. Follow the direc-
tions in the Erasing an Existing Route section to start with an empty
route if you have waypoints in the RTE1 screen.
To perform this function, you must also have defined a route in the
RTE2 screen. The RTE2 description follows later in the Route sec-
tion.
1. Select the RTE key until the RTE1 screen is displayed.
2. Press the EDIT key to enter the edit mode.
3. Highlight Insert softkey from the display and press ENT. Skip to
4. Highlight Insert Route softkey from the display and press ENT.
5. Use the cursor key to scroll through the available defined routes,
6. When you have found the route you want, highlight the Insert
42
you are using other coordinate systems). Use the EDIT keypad to
type in the range and bearing from the previous waypoint (or
present position in the case of the first waypoint) or the coordi-
nates you want and their appropriate description.
press ENT.
method, select Escape to go back one level and use another method
to enter waypoints, or select Done to go back to the main menu.
the next step if RTE1 is empty.
which are created in the RTE 2 screen, in numerical order.
Route
Version 3.0