Table of Contents
Advertisement
Operator's Manual
Appendix C - Engineering Mode
The Engineering Display, which is activated in CFG1 Operation, en-
ables an expanded series of display screens in some of the functions.
In general, these screens are used by the technician during trouble-
shooting or by BNT-ME engineers during testing and software de-
bugging. This section describes what information is relevant to you,
or the information we need to help you troubleshoot your MX500.
Note: Information which is not described here is un-
If you should enable these screens, they will be turned off automati-
cally the next time power is cycled on the MX500.
AUX7 - Unit Information & Self Test
When the Engineering Display is active, the AUX7 screen adds one
line of detail to display the engineering level that is turned on:
In addition, you can press the EDIT function key and run a complete
self test by highlighting the Make Selftest softkey then pressing ENT.
The first display of the self test is a keypad test. Press each function
and softkey once. When you have pressed each once the test will
automatically advance to the Traffic Light test. Observe that the three
traffic lights go from dim to bright. Highlight the OK softkey then
press ENT if they illuminate correctly or Fail if they don't.
168
supported, which means BNT-ME will not ex-
pand or provide any more information than
what is provided in this manual.
Engineering Mode
Version 3.0
Advertisement
Table of Contents
Troubleshooting
