NorthStar MX500 Operator's & Installation Manual page 128

Operator's Manual
Alarm on health change - Sets the alarm to On or Off if the satellite
WAAS/EGNOS enabled - sets the source of differential correction to
External DGPS Enabled - gives the user the capability to accept RTCM
114
is Yes. If the alarm is set to Yes, you should notice that the
receiver drops out of DGPS mode and into the mode selected in
DGPS Mode described earlier in this section at the same time
the alarm sounds.
becomes unhealthy or unusable.
come from satellite based augmentation system such as US-WAAS
or European-EGNOS system. Although this systems are available,
they are still not considered as IMO compliant systems. Use of
these differential correction sources should be done with great cau-
tion.
SC-104 corrections from an external beacon receiver (Coastguard or
a Private Beacon Reference Station). The MX500 allows you to
control the baud rate of SC-104 Data input port. The following baud
rates can be used - 2400, 4800, 9600, 19200.
Note: WAAS/EGNOS and External DGPS are available only for
the MX521 or MX525 antenna with the MX 500 CDU.
Configuration
Version 3.0