ComAp InteliCompact NT Reference Manual page 263

Binary output: AL Reverse Pwr
Related All
applications
Description This output is active when the
alarmlist.
Binary output: AL Start Fail
Related All
applications
Description This output is active when the
Binary output: AL Stop Fail
Related All
applications
Description This output is active when the
Binary output: AL Sync Fail
Related All
applications
This output is active when the
Description
in the alarmlist.
Binary output: AL Batt Volt
Related All
applications
Description This output is active when the
alarmlist.
Binary output: AL Earth Fault
Related All
applications
Description This output is active when Earth Fault Current alarm is present in alarm list
(extension module
Binary output: BI1 Status
Related All
applications
Description This output gives information about the status of binary input 1 of the
controller.


NT
InteliCompact , SW version 2.1
InteliCompact-NT-2.1-Reference Guide.pdf, ©ComAp – May 2015
reverse power alarm
start fail alarm
stop fail alarm
Sync Timeout
Battery voltage
IC-NT CT-BIO7
If the related binary input is configured as an alarm input, the output
is closed when the assigned alarm is present in the alarmlist.
If the related binary input is configured as functional, the output
copies directly the status of the input.
is present in the
is present in the alarmlist.
is present in the alarmlist.
or RevSyncTimeout
or Battery flat is present in the
is needed).
is present
263